ProKevLock Anti-Theft Security Gear

Sixteen ounces empty, in a 12 x 9 x 3 inch footprint. That thin depth is what keeps it reading as a normal grey crossbody rather than a security product on a shoulder. Note that one spec field on the retail spec sheet shows a conflicting cube measurement that does not match the physical bag; the bullet-point figure above is the accurate one.

A heavy-duty 304 CRES steel cable, 3/16 inch in diameter, closes the bag opening and loops around fixed objects. Cinch the cable to gather the opening shut, then wrap it around a chair leg, table base, or umbrella pole and lock it. Reviewers note that pulling the cable fully tight takes hand strength the first few times, then becomes routine.

A quarter-turn master keylock with a piston-operated mechanism. Turn the key a quarter rotation and the compression lock releases for one-hand retrieval, with no combination to dial and no keypad battery to fail in a cold vehicle. The lock also self-engages if someone tampers with it. The manufacturer states there is no master key for the device.

EVA foam padding lines the interior and cradles a handgun so it does not shift or rattle in a range bag. The shell is nylon with a UHMWPE fabric outer and a steel-reinforced layer beneath. It is a flexible pouch rather than a rigid box, which is why it folds into a glovebox but does not resist crushing the way a hard case would.

The compression lock tightens rather than loosens under pull. Yank on a cover or work at the case lock and the mechanism engages further instead of backing off, so casual tampering makes the lock tighter rather than looser. That is the behavior called out on both the mirror covers and the pistol case, and it is why a driveway tug test is a reasonable final install step.

304 CRES is a corrosion-resistant stainless grade, used here for both the mesh layer and the cable. On a mirror cover living outdoors through road salt, rain, and freeze cycles, corrosion resistance is what keeps the mesh from pitting and the cable from seizing after a winter. A plain steel mesh would rust where the fabric holds moisture against it.

Weight is not published for the pistol case, which is a gap worth naming rather than guessing at. What is documented: a nylon shell, EVA foam interior padding, and a UHMWPE fabric outer, in a flexible form that folds rather than holds shape. For reference, the mirror-cover set runs 0.89 kg and the crossbody bag 0.41 kg empty.

The current mirror cover is marked Version 3, which refers to the manufacturing generation rather than a feature mode. The change that matters in Version 3 is the 304 CRES steel mesh mid-layer, added under the outer fabric as the dedicated anti-cut element. Earlier generations relied more heavily on the fabric alone.

A 2-year manufacturer warranty applies to the mirror-cover set. It is not stated for the crossbody bag or the pistol case, and this page does not stretch it to cover them. Practically, that means a cracked liner, a failed cable, or a seized lock on the covers inside two years is a manufacturer conversation, while the other two pieces fall back on the retailer's return policy.

Independent lab testing and certification are absent for all three pieces. The material claims describe the construction, UHMWPE/HPPE fabric over a steel wire layer, and not a certified cut-resistance rating. If a certification level is a purchase requirement for you, treat that gap as a reason to look at a brand publishing test results.

Slash-resistant slows a blade; it does not stop one. That distinction is the honest framing across this whole category, and it is why the language here stays at cut-resistant rather than absolute. Fabric plus a steel wire layer forces a thief to saw rather than slice, which turns a quiet three-second job into a conspicuous one. That is the actual mechanism.

There is no RFID-blocking pocket in the PurTraSafe, and no shielded card sleeve ships with it. Competing travel bags from Pacsafe and Travelon commonly include one, so if contactless card shielding is on your list, either carry a separate RFID sleeve inside the bag or buy a model that builds it in. That is a real gap, not a spec oversight.

Returns run through the retailer's standard 30-day window. Test fitment the day the box arrives rather than saving it for a trip: wrap both covers, thread the cable, lock it, and pull. If the cover fouls an unusual mirror shape or the cable will not reach behind a towing arm, that is the moment to send it back.

Because several buyers cut it and reported exactly that. Reviews on the pistol case dispute the anti-cut claim directly, describing the fabric as cutting with a plain blade. That feedback is why this page uses qualified cut-resistant language for the case and points buyers who need certified protection toward a bolted steel safe instead. The mirror covers, rated by 642 buyers, do not carry that complaint pattern.

Treat it as access control, not a certified safe. It is a flexible locking pouch that keeps a firearm out of casual reach, and the manufacturer describes it as stopping children from reaching the firearm or trigger. It is not a certified child-resistant container, and cut-resistance complaints in the reviews reinforce that. Check your state requirements and pair it with a proper safe.

Support is the most-praised item across reviews on both the covers and the bag. One buyer who lost a key years after purchase reported the owner reaching out personally to help. Another wrote that the owner explained how to maintain the locks through New York temperature swings. Not every buyer gets that outcome, and at least one review reports no reply, so treat it as a pattern rather than a promise.

The product copy references national news coverage, and no independent confirmation of that exists in the source material, so it is not used as proof anywhere on this page. The claims worth weighing are the ones you can check: a 4.7-star average across 642 verified buyers, a published warranty term, and the material spec on the box.

Under five minutes for both mirrors, working unhurried. Slide the cover over the mirror housing, pull the fabric snug, feed the cable behind the mirror arm, tuck the slack inside, and turn the key until the compression lock clicks. One owner in Europe timed it at a maximum of five minutes to secure both sides. No drill, no adhesive, no holes.

A light lubricant on the cable and lock body frees it. One owner parking in the Bronx reported the lock sticking, then solved it permanently by carrying a small can of penetrating spray and treating the mechanism before winter. Do it in November rather than January, and repeat after a car wash, since water sitting in the cylinder is what freezes overnight.

Folding behavior with the cover installed is not documented in the product specs, so it is worth asking the manufacturer before ordering if you fold your mirrors nightly in a tight garage or narrow street. The cover wraps the housing and cinches with a cable behind the mirror arm, which is the area that moves during a power-fold cycle.

Weather protection is the second job it does. The fabric takes bird droppings, frost, and snow that would otherwise sit on the glass, so morning scraping moves to the cover instead of the mirror. Pull the cover off and the mirror underneath is clean and dry, which matters more in a salt-heavy winter than most buyers expect going in.

Cinch the cable to close the bag opening first, then wrap the remaining cable around a chair leg, table base, or umbrella pole and lock it. One reviewer found the technique on the manufacturer's images: wrap the cable around the neck of the bag as if choking it, then attach to something rod-shaped so no hand fits through the opening.

The mesh and cable are both steel, so expect the bag to register at a walk-through checkpoint the same way a laptop or a belt buckle does. Send it through the X-ray belt like any other carry item rather than wearing it through the arch. Security screening behavior is not documented by the manufacturer, so allow extra time on a first trip.

A quarter turn of the key releases the piston mechanism for one-hand retrieval. Mechanical locks like this one avoid the failure mode biometric and keypad models carry in extreme temperatures, where a dead battery or a cold sensor delays entry. The trade is that you must know where the key is, in the dark, without looking. Practice that before it matters.

A bag that advertises security invites attention; a plain one does not. The PurTraSafe reads as an ordinary grey crossbody, with the cable tucked into the body rather than hanging off the strap. Nothing on the outside signals valuables. That matters more than the fabric spec in a crowded tourist district where thieves scan for the person guarding something.

Pacsafe and Travelon build deeper travel ranges with RFID-blocking pockets, more compartment layouts, and wider style choice. The PurTraSafe counters on the closure: a 3/16-inch 304 steel cable that both shuts the bag and anchors it to furniture, plus a steel wire layer under the fabric. If RFID shielding or compartment organization ranks high for you, buy theirs.

A lockbox controls access, usually bolted or cabled to a fixed point so it cannot be carried off. A case protects the firearm during transport and movement. This pouch sits between the two: it locks like access control but folds like a transport case. That is why it works in a nightstand drawer or a range bag, and why it never replaces a bolted safe.

An unlocked cover keeps sun, frost, and droppings off the glass and comes off in one motion, which is exactly the problem when the motion belongs to a thief. Adding a keyed steel cable and a wire layer changes the calculation: the mirror can no longer be exposed and popped in a few quiet seconds on a dark street.

A zippered purse opens to any hand that reaches it in a crowd, and it cannot be tied to a chair while you eat. Those two gaps are the whole argument for a locking bag. The trade is speed: reaching your own wallet takes a key and a cable rather than one zipper pull, which some buyers find slow at a checkout counter.

A flexible pouch never replaces a bolted steel safe. This one restricts casual access, travels in a range bag, and locks itself under tampering, which covers a nightstand drawer or a vehicle console. It does not resist a determined attack, and buyer reviews dispute its cut resistance directly. Use it as a second layer alongside a real safe, not instead of one.

Four keys ship with every mirror-cover set precisely because this is the most common post-purchase problem. Store at least two away from the vehicle, since a key locked inside a covered mirror helps nobody. Buyers who exhausted their spares report contacting the manufacturer directly through the brand website and getting replacements sorted, which several reviews describe in detail.

Light lubrication on a schedule. Treat the cable and lock body before the first freeze each year, and again after any wash where water sits in the cylinder. Owners in cold climates who follow that routine report the lock turning normally into a second winter, while those who skip it report a key that will not budge on the first frozen morning.

Spot cleaning is the safe method. Machine washing is not documented for a bag built around a steel wire layer, and tumbling that construction risks distorting the mesh and soaking the interior. Wipe the outer fabric with a damp cloth and mild soap, then air dry fully before locking it away, since trapped moisture is what corrodes a cable over time.

One owner reported over a year of continuous use with no mirrors lost since installing. Another described a bag surviving years of weather, beach trips, and being thrown in the back of a car, still working like the first day. Corrosion-resistant steel is the reason the mesh and cable survive road salt where plain steel would pit within a season.

Key interchangeability across pieces is not documented, and assuming it would be a mistake: the covers use a cable compression lock while the pistol case uses a quarter-turn master keylock, which are different mechanisms. Ask the manufacturer directly before ordering a replacement, and label the keys by product when you unbox so you are not testing four keys in the dark.